Has MS CAMS PAGE been changed?

[flabbs]

So frustrated I am. Have been trying to figure this out for hours. Am so computer dumb.

Cams list worked just fine this morning. About 2-3 hours ago it quit.
I always use it to click on the cams links and alert monitor. Cams from this morning are still up and OK. If I close it, I can't get it back by using cams page.

Just clicking now on cam link for any ranch/farm and link for alert monitor does absolutely nothing. Why?

[bndranch]

I just opened the cam page by clicking the Cams link below......Not sure whats going on but I hope you can figure it out or have Rich the wonder man help you LOL!

[flabbs]

Thanks bnd for trying to help.

I have no problem opening the cam page ... it's when I click on a specific cam on that page that nothing happens ... or click on alert monitor and nothing happens. Don't know why it all worked earlier and now is just dead for me.

[bndranch]

Not sure I just clicked on the cam link then went to a cam and it opened right up. Maybe PM Rich or hopefully he will see this post soon!

[rich]

Most of the links on that page make use of Javascript to load popup windows. Make sure you don't have a popup blocker enabled that would prevent cam pages or the alert monitor from loading. If you think you might, you can try holding down the CTRL key when you click on a link. If the cam page opens, then that is your problem. You need to either turn off your popup blocker, or set marestare.com as one of the sites where popups are allowed.

[flabbs]

Rich: Sorry to take so long to reply. Thanks for the suggestions.

But I guess it will remain a mystery. I checked and tried everthing you suggested and there was no change.

Still don't understand why it suddenly stopped working after using it for months.

Anyway, just did a System Restore and was able to use the links on the cam page again. Hurray. Hope it never happens again.